It s possible the drain hose extends more than 4 5 114 mm into the standpipe.
Maytag centennial washer door lock flashing.
The maytag centennial washer s tub is suspended on 4 suspension rods located on the outer corners of the washer s tub.
Next thing to do is unplug the washer for about 5 minutes.
Front loaders have a locking mechanism to avoid opening the door during a washing cycle but occasionally this lock will be activated accidentally.
My 36 month old maytag washer mvwc300vw1 had a sensing light and a blinking lid lock light.
Centennial washer should spin for 10 seconds wash rinse lock centennial washer should coast to a stop for 30 to 45 seconds wash rinse done lock centennial washer lid lock should unlock in 1 second and not longer than 3 minutes wash rinse spin.
Maytag bravos lid lock bypass this trick actually works permanently with no extra switches or magnets or lights.
365 day return policy.
If f8 e1 or lf too long to fill appears in the display the washer is taking too long to fill or the washer is filling and draining.
Fixed mvwc200xw2 maytag centennial no spin flashing lid lock.
Door latch w10404050 order now for same day shipping.
Here s the lid lock switch for your model.
I followed the advice from many on the net and serviced the lid lock switch.
1 of 2 go to page.
Did you receive an lf or f8e1 error code or is the spin or wash light blinking.
Machine filled with water now nothing.
Tried to wash a load of clothes.
Red lid lock light was flashing when i came in from work.
Have maytag centennial washer about 7 months old.
The spring portion of these tub suspension rods have been known to become soft and allow the tub to bounce leading to the washer regularly going off balance and banging the inside of the washer during spin.
Green light is on sa read more.
Centennial co october 20 2014.
When the lock light is blinking it typically means that the unit either took to long to fill with water in which case it ll go into flood mode and keep draining for 15 20 minutes and unlock on it s own or there is a glitch in the electronics and just unplugging it for 60 seconds will reset the issue.